MIYO CALENTADOR DE NÚCLEO CALIENTE CO., LIMITADO

Hogar > Resistencia al calentamiento líquido

Resistencia al calentamiento líquido

Immersion heater element Immersion heater element is made of stainless steel pipe with spiral heating wire as heating element.Fully comply with GB/T241993 electrical and electronic products basic environmental test procedures, and gb4706.1-19921 household and similar electrical safety requirements.

Detalles del producto:

Product description:
water heating tube
Tipo: electric water heater accessories
Brand name :NÚCLEO CALIENTE
Modelo: TU – 504
Material: SUS304
Tube diameter :8 milímetros
V: 110-240 V
Vatio: 1000-5500W.
Fran: 2 “Triclamp (OD64mm)
Forma: ripple
Use: water heating
Tipo: elemento calefactor
Clase: water heater element

Instructions:
1 The heated liquid does not contain materials that should not be corroded by the components. The scale or carbon deposition on the surface of the tube should be removed frequently during use, otherwise the efficiency and service life of the components will be affected.
2. The operating voltage of the heating element shall not exceed 1.1 times of its rating, the environmental humidity shall not exceed 95%, and the enclosure shall be effectively grounded.
3. The electric heating element of the water heating pipe should be stored in a dry place, because be placed for long if its insulation resistance to earth less than 1 Oh, Oh, can be in around 200 ℃ oven drying resumed after several hours.
4. When the water heating pipe is tightening the thread, don’t push the thread too hard.

Escríbenos

Relacionar producto

Más vídeos

1
Elemento calefactor de silicona personalizado
fabricantes de terminales de pestaña
Terminal calentador tubular
Pasador paralelo de rodillos de rodamiento personalizado
parte de la cabeza del termopar

ENLACES RÁPIDOS

CONECTAR

+86 15521310300
EXPORTAR@HXHEATER.COM

Derechos de autor © 2024 Estudio de Arquitectura
Desarrollado por hxheater

Desplazarse hacia arriba

Formulario de contacto